Electrical submersible pumps



Technical characteristics

  • Minimum internal diameter of the production casing, inch
    4,79
    5,11
    5,83

  • Body diameter, inch

    3,62
    4,06
    4,49

  • Reservoir fluid supply in working area, bbl per day
    91-1172
    265-7186
    7186-11724

  • Head, ft

    656-13000
    492-12300
    492-6725


Design features

  • Floating configuration with axial support in the section (optimized for limited content of abrasive particles in reservoir fluid)

  • Floating configuration without axial support in the section (optimized for high concentration of abrasive particles in reservoir fluid)

  • Packet assemble scheme (optimized for severe conditions with high concentration of abrasive particles in formation fluid)

  • Compression configuration (optimized for severe conditions with high temperature of reservoir fluids and with high concentration of solid particles and gas)


Gas separators



Technical characteristics

  • Minimum production casing inside diameter, inch
    4,79
    5,11

  • Body diameter, inch

    3,62
    4,06

  • Formation water supply in working area, bbl per day
    75-3800
    190-3800

  • Separation gas ration

    0,6-0,75
    0,6-0,7


Design features

  • Gas Separators
    - reduce the amount of free gas in the formation fluid at the pump intake;
    - protect from gaslocks appearing;
    - provide stable performance of ESP;
    - Reduces MTBF (minimum time before failure).

  • Dispensers
    - converts reservoir fluid into the homogeneous mixture;
    - eliminates or minimizes the influence of free gas on stages;
    - reduce flow vibration and pulsation in oil well tubing;
    - provides the the pump KPI efficiency;
    - reduce spurging.

  • Gas Separators - Dispensers
    - reduce the amount of free gas;
    - dispense gas inclusions;
    - converts reservoir fluid into the homogeneous mixture at pump intake ;
    - installed in wells with especially high GOR (gas to oil ratio), where nither gas separators, nor the dispensers can't provide stable ESP performance.




Electric or induction motor



Technical characteristics

  • Minimum production casing inside diameter, inch
    4,79
    5,11
    5,83
    6,3

  • Body diameter, inch

    3,78
    4,06
    4,60
    5,12

  • Enviroment temperature, °F

    194
    248
    302
    390

  • Power, hp

    26-274
    26-338
    26-579
    112-724


Design features

  • Output from zero point of the stator circuit

  • Closed-type stator slot

  • Slot insulation with the usage of teflon tube

  • Mechanical fixation of the guide bearing to avoid cranking


Protector


Technical characteristics

  • Minimum production casing inside diameter, inch
    4,79
    5,11
    5,83

  • Body diameter, inch

    3,62
    4,06
    4,49

  • Power of motor, hp

    max 380
    max 490
    max 611


Chambers design features

  • Diaphragm – Labyrinth – Labyrinth

  • Two diaphragms are connected in parallel (form a single cavity) – Labyrinth

  • Two diaphragms are connected in series (form a single cavity split
by face seal and valve) – Labyrinth

  • Labyrinth – Diaphragm

  • Labyrinth – Two diaphragms are connected in parallel (form a single cavity)

  • Labyrinth – Two diaphragms are connected in series (form a single cavity split
 by face seal and valve)